By Ram Raghuraman · 2026-11-17 · Also published on LinkedIn
A 25-30% rejection rate.
That’s what a US home hardware retailer was living with when we started working together. Roughly one in four pieces from their Indian factories failed, and most failures were only found in the US, after the goods had already crossed an ocean.
When we dug in, the factories weren’t careless. Nobody had ever told them what “good” looked like. No material specs, no tolerances, and drawings in inches for workshops that think in millimetres.
So we fixed the inputs, not just the inspection:
- Detailed drawings for every SKU, with tolerances, converted to metric.
- A quality guide showing each factory exactly what counts as a defect.
- Jigs and fixtures, worked out with the suppliers, so the most common errors couldn’t happen in the first place.
- Pre-shipment audits by our inspectors in India, so anything that slipped through was caught before it went into a container.
Photo: the team checking pieces one by one before anything was packed.
The rejection rate came down to under 2%.
None of this is clever. It’s being on the factory floor early, and staying there until the factory’s own process does the work.
If quality is the reason you hesitate on India, tell me what you’re making. Happy to share what I’d check first.
Read the full case: Modern Matter
Ram Raghuraman is the founder of BCube Global Solutions, a CPSM and a Director at ISM India.
If this sounds like your supply chain, book the diagnostic.
Free. No obligation. A written summary within two business days.
Book a 30-minute India sourcing diagnostic
You speak with me, not a salesperson.